Please email your question to AskFOC@focenter.com and we will respond ASAP. In addition to replying, we will post your question and our answer here on the AskFOC page. Everyone remains anonymous when we post so feel comfortable asking your questions. You can also search to see if your question has already been answered in the FAQs section below.
QUESTION:
What are the different types of standards for MT/MPO measurements using interferometry?
ANSWER:
There are two types of IEC standards for MT/MPO measurements using interferometry.
The first is the “Measurement Standard” and its primary...
QUESTION:
What causes the Apex of a radius to be imperfect, to be off-center?
ANSWER:
Angles do. Angles create Apex Offset. Apex Offset is the result of polishing at an angle. The ferrule being at an angle to the polishing surface during polishing...
QUESTION:
How do we decide which passive component tester to purchase?
ANSWER:
The passive component tester (PCT) – must be correctly configured by the seller to support your product requirements. Start by answering these 7 foundational questions....
QUESTION:
We are a fiber optic cable assembly manufacturer. For epoxy bi-packs, what are the typical package sizes?
ANSWER:
For fiber optic cable assembly manufacturers, bi-packs of 2.5-gram and 4-gram are typical package sizes for epoxy. While these...
QUESTION:
When working with epoxies, are there different types of skin irritations or allergies?
ANSWER:
The two types of Contact Dermatitis are Irritant and Allergic:
Irritant Contact Dermatitis is an inflammatory reaction that occurs after damage to...
QUESTION:
How many options are there for troubleshooting why a connector failed?
ANSWER:
There are 4 diagnostic methods that can help to troubleshoot why a connector failed. They are:
In-house optical diagnostic process and tools
X-ray inspection...
QUESTION:
How can we figure out the ideal fiber height for fiber optic connectors?
ANSWER:
In reality, there is no ideal fiber height. I recommend aiming for a target fiber height of +/-20 nanometers. I have personally pursued the question – What is the...
QUESTION:
How do you ensure proper bond line thickness?
ANSWER:
Plan to test your bond line thickness – and other epoxy processes – to ensure they are optimal for your application.
Remember this rule of thumb: “The application dictates.”
When...
QUESTION:
What is the recommended needle size to dispense epoxy?
ANSWER:
With so many unique applications as well as connector sizes, the answer to this question truly does depend on your application. Needles range in gauge size and length; some have a...
QUESTION:
How can you decrease and increase Radius values?
ANSWER:
Generally speaking, the smaller your average Radius value, the smaller the deviation in results will be. It is usually a good idea to aim for the lower end of the Radius specification...
