QUESTION: We have an 8º MT polishing fixture and are getting polished angled less than 7.9º. Is there a problem with the polishing plate?
ANSWER:
Assuming you are using high quality polishing equipment, it is most likely NOT an issue with the...
QUESTION: How long should it take to polish a plate of 48 LC start to finish?
ANSWER:
The short answer is around 15-20 minutes including loading and unloading. The actual polish time usually doesn’t change as the quantity of connectors being...
QUESTION: We are polishing some 12 fiber MT ferrules and found that the edge fibers (1, 2, 11 and 12) are on the lower end. Is this normal?
ANSWER:
While an infinite or perfectly flat radius across all fibers is the goal, it’s next to impossible to...
