In addition to failures due to the light loss, there is the possibility of equipment failure and the nightmare of unexpected costs for troubleshooting, replacing and fixing damages.
Fiber Installation Cleanliness Resources:
- Cisco had this information under their Inspection and Cleaning are Critical section (http://bit.ly/1JHMGuo) that illustrates the delicacy of the situation: "A 1-micrometer dust particle on a single-mode core can block up to 1% of the light (a 0.05dB loss). A 9-micrometer speck is still too small to see without a microscope, but it can completely block the fiber core. These contaminants can be more difficult to remove than dust particles. By comparison, a typical human hair is 50 to 75 micrometers in diameter, as much as eight times larger. So, even though dust might not be visible, it is still present in the air and can deposit onto the connector."
- The International Electrotechnical Commission (IEC) created Standard 61300-3-35, which provides guidelines about the size and amount of dirt and contamination for single and multi-fiber end-faces and also specifies both the pass/fail requirements for endface quality and a process to verify the connector meets these requirements.
READ THE BLOG: Ensuring Clean Fiber Connections
Additional resources from the FOC team include:
- Category Resource:
- View the Glossary, Acronyms, Military Specifications for Connectors
- Q&A Resource: email technical questions to AskFOC@focenter.com
Have questions about this FOC Tip?
Contact FOC with questions at: (800) 473-4237 / 508-992-6464 or email: FiberOpticCenter@focenter.com and we will respond ASAP.
This article is an original publication of Fiber Optic Center, Inc. It is shared publicly for educational and reference purposes to support learning and professional development within the fiber optics industry.
You are welcome to read, cite, or reference this material for non-commercial and educational purposes, as long as full credit is given to Fiber Optic Center, Inc. and the author.
Reuse, reproduction, or adaptation of this content — including rewriting, republishing, or incorporating it into new materials (such as websites, blogs, marketing text, technical guides, or AI-generated content) — is not permitted without prior written consent from Fiber Optic Center, Inc.
This material is protected by copyright law upon publication, even if not formally registered.
Use of this content for AI training, automated data extraction, or derivative content generation is prohibited.
Fiber Optic Center monitors and enforces the integrity of its intellectual property through digital identifiers and content tracking.
For more details, please refer to the Fiber Optic Center Content Use and Copyright policy.
