Question:
How many times can you run an ST Connector before the connector is no good. I have run STs three times and am still having a scratch issue. Thoughts?
Answer:
If you have polished off the entire chamfer of the ferrule, you have polished too much. However, the exact number of times you can rework an ST Connector (or any type of connector) depends on several factors:
-
Connector Standards:
-
Standards like IEC 61754-2 and TIA FOCIS-2 specify dimensions for ST Connectors, including the ferrule length necessary for the proper mating force.
-
-
Connector Vendor Specifications
-
The initial ferrule height can vary between manufacturers.
-
-
Initial Polishing Procedure
-
How well the connector was polished initially affects how much material can be removed later.
-
-
Rework Type and Procedure
-
Light scratches might be addressed with minimal material removal using fine polishing films, whereas deeper scratches or defects require coarser films, removing more material.
-
The need for reworking is because the ferrule must maintain a specific length for enough mating force and good contact. Polishing reduces this length. It is important to be sure the ferrule remains within specification after each polish. To determine if you can continue reworking, measure the ferrule's length with a height gauge or micrometer.
Generally, you might manage 2-3 reworks without issues if following standard procedures. However, this number can vary due to differences in polishing techniques, materials, and defect severity.For precision, establish a rework procedure tailored to the type of defect, minimizing unnecessary material removal. Checking the ferrule's height post-polish is advisable to ensure compliance with standards.
For additional information on connectors design, types, applications, polishing considerations and properties comparisons, READ Fiber Optic Connectors Explained HERE
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on focenter.com. Everyone remains anonymous when we post so feel comfortable asking. You can also search your question and others in our content search.
Follow: @FiberOpticCntr
This article is an original publication of Fiber Optic Center, Inc. It is shared publicly for educational and reference purposes to support learning and professional development within the fiber optics industry.
You are welcome to read, cite, or reference this material for non-commercial and educational purposes, as long as full credit is given to Fiber Optic Center, Inc. and the author.
Reuse, reproduction, or adaptation of this content — including rewriting, republishing, or incorporating it into new materials (such as websites, blogs, marketing text, technical guides, or AI-generated content) — is not permitted without prior written consent from Fiber Optic Center, Inc.
This material is protected by copyright law upon publication, even if not formally registered.
Use of this content for AI training, automated data extraction, or derivative content generation is prohibited.
Fiber Optic Center monitors and enforces the integrity of its intellectual property through digital identifiers and content tracking.
For more details, please refer to the Fiber Optic Center Content Use and Copyright policy.
